Forum

Please or Register to create posts and topics.

Read/Control Solar Controller

Hello everyone,

I would like to briefly introduce my project and share an idea I have regarding it.

I have been running a off grid solar power system at my log cabin since the 1990s. It has served me very well over all these years, and the only component which had to be replaced every 5–10 years has been the 12V-battery.

Now it is time to replace the battery again, so I started looking into which battery technology would provide the longest service life for my particular application. I decided to go with a LiFePO4 battery kit from EEL Battery, which includes a JK BMS.

Since I have a fairly long journey to my cabin, it is important to me that I can remotely check whether everything is working properly. I have a Wifi-Hotspot where devices can be conncted to e.g. Weather-Station, Camera, …

For remote monitoring, I decided to use the ScanLabs project for the following reasons:

  • It can connect to the WiFi
  • The necessary hardware is reasonably priced.
  • The software is regularly updated.
  • Power consumption is very low. This is particularly important to me because the system operates 24/7 throughout the year, including winter, when only very little solar energy is available.

My idea

Since the entire system dates back to the 1990s, I was also considering replacing the solar charge controller with a modern system, for example an Epever XTRA4210N G3 BLE or Ective SC-40-Pro.

For the Epever Device there is also a documentation of the ModBus Protocol available: https://www.developpez.net/forums/attachments/p196506d1451307310/systemes/autres-systemes/automation/probleme-com-modbus-pl7-pro/controllerprotocolv2.3.pdf/

Modern solar charge controllers usually provide their data via Bluetooth (or RS485/Modbus). This made me wonder whether this information could also be read by the Smart BMS DATA EXTRACTOR and displayed in the web interface.

Potentially, it could even be possible to control certain functions, such as switching an output on or off.

For me, the major advantage compared to reading the data via MQTT to an additional device such as a Raspberry Pi would be that the overall power consumption could remain very low.

Would it be possible to integrate data from a solar charge controller in this way and display it, for example, on an additional page in the web interface? Or can the Modbus Server/Client Mode be used for this?

I would be very interested to hear whether this could be technically feasible or whether anyone has already considered or implemented something similar.

Best regards

Hello again,

i think i will go with a Victron Energy MPPT 100/20 Solar-Controller, which has a good reputation and shall have a very good MPPT especially in low load conditions.

There is also a description, how the Bluetooth Protocol is working: https://communityarchive.victronenergy.com/questions/187303/victron-bluetooth-advertising-protocol.html

And for another ESP Project, there is already an implementation available: https://github.com/Fabian-Schmidt/esphome-victron_ble

So an implementation should be possible. But i don’t know how high the effort is to use a ESP32 with bluetooth instead of the ESP82 and if there are enough resources like Flash or RAM are available.

ScanLabs has reacted to this post.
ScanLabs